I'm following the guide to set up a four-node Proxmox Ceph cluster on my Dell c6100.
https://pve.proxmox.com/wiki/Ceph_Server
Each node has dual gigabit ethernet and dual infiniband adapters. Everything has gone smoothly until I get to pveceph createmon, where it apparently can't find an address even though it is clearly configured, available, and working.
The Proxmox cluster is configured on ib0 and working properly as far as I can tell. There are no errors, and all the nodes show fine in the web interface. The ceph cluster is intended to be on ib1, but I can't create the monitor for some reason. Any ideas?
https://pve.proxmox.com/wiki/Ceph_Server
Each node has dual gigabit ethernet and dual infiniband adapters. Everything has gone smoothly until I get to pveceph createmon, where it apparently can't find an address even though it is clearly configured, available, and working.
Code:
root@pve1:~# cat /etc/network/interfaces# This file describes the network interfaces available on your system
# and how to activate them. For more information, see interfaces(5).
# The loopback network interface
auto lo
iface lo inet loopback
# The primary network interface
allow-hotplug eth0
iface eth0 inet manual
bond-master bond0
allow-hotplug eth1
iface eth1 inet manual
bond-master bond0
auto bond0
iface bond0 inet static
address 192.168.1.21
netmask 255.255.255.0
gateway 192.168.1.1
dns-nameservers 192.168.1.5 192.168.1.1
bond-mode 6
# infiniband interfaces
allow-hotplug ib0
iface ib0 inet static
address 10.13.37.21
netmask 255.255.255.0
allow-hotplug ib1
iface ib1 inet static
address 10.13.38.21
netmask 255.255.255.0
root@pve1:~# ping 10.13.38.22
PING 10.13.38.22 (10.13.38.22) 56(84) bytes of data.
64 bytes from 10.13.38.22: icmp_req=1 ttl=64 time=0.068 ms
64 bytes from 10.13.38.22: icmp_req=2 ttl=64 time=0.051 ms
64 bytes from 10.13.38.22: icmp_req=3 ttl=64 time=0.045 ms
^C
--- 10.13.38.22 ping statistics ---
3 packets transmitted, 3 received, 0% packet loss, time 1999ms
rtt min/avg/max/mdev = 0.045/0.054/0.068/0.012 ms
root@pve1:~# pveceph init --network 10.13.38.0/24
root@pve1:~# pveceph createmon
unable to find local address within network '10.13.38.0/24'