Hi there,
I am currently trying to create a setup, that looks like this:
With my current config I have the BRIDGE0.10 Interface working as the Proxmox Management IF.
But when i use my bridge0 for a network interface (VirtIO - no vlan) and create ETH0.10 inside the VM,
ETH0 is only able to communicate with BRIDGE0.10, while BRIDGE0.10 can comunicate with the whole network.
If I configure my network interface (Virtio - vlan 10), eth0 inside the VM works as expected.
The goal of my setup is to have a firewall running inside the vm with access to all vlans on the switch. More important, I want to be able to add a new vlan on the switch, and to acess it by creating a new vlan device inside the VM without restarting.
Also, here an attachment of my current config:
Does anybody know, what is blocking the VM from communicating to the outside given my setup?
Thanks
I am currently trying to create a setup, that looks like this:
Code:
+-----+ +-----+
|ETH0 | |ETH1 |
+---+-+ ++-----+
| |
+-+-----+-+
| BOND0 |
+----+----+
|
|
+----+-----+ VLAN.10 +----------------+
| BRIDGE0 +-----------+ BRIDGE0.10 |
+----+-----+ +----------------+
| |IP: 10.0.14.6/24|
TRUNK | | |
+----------+ +----------------+
|
| +-----------------------------------+
| | VM |
| +-----------------------------------+
+---+ ETH0 |
| +-ETH0.10 |
| +-ETH0.20 |
| |
| |
| |
+-----------------------------------+
But when i use my bridge0 for a network interface (VirtIO - no vlan) and create ETH0.10 inside the VM,
ETH0 is only able to communicate with BRIDGE0.10, while BRIDGE0.10 can comunicate with the whole network.
If I configure my network interface (Virtio - vlan 10), eth0 inside the VM works as expected.
The goal of my setup is to have a firewall running inside the vm with access to all vlans on the switch. More important, I want to be able to add a new vlan on the switch, and to acess it by creating a new vlan device inside the VM without restarting.
Also, here an attachment of my current config:
Code:
# This file describes the network interfaces available on your system
# and how to activate them. For more information, see interfaces(5).
# The loopback network interface
auto lo
iface lo inet loopback
# bonding eth0 and eth1
auto bond0
iface bond0 inet manual
bond-mode 802.3ad
bond-miimon 100
bond-lacp-rate slow
bond-slaves none
# The hardware network interfaces
auto eth0
iface eth0 inet manual
bond-master bond0
auto eth1
iface eth1 inet manual
bond-master bond0
auto vmbr0
iface vmbr0 inet manual
bridge_ports bond0
bridge_stp off
bridge_fd 9
#new VLAN on bridge Interface as managment interface
auto vmbr0.10
iface vmbr0.10 inet static
vlan-raw-device vmbr0
address 10.0.14.6
netmask 255.255.255.0
gateway 10.0.14.1Thanks