Just installed a new cluster at a clients site. Getting message like the ones below quite often. Mar 27 16:32:15 fpracprox1 kernel: [bnx2x_gro_receive:832(eth1)]Error: FW GRO supports only IPv4/IPv6, not 0x8100All inhouse clusters and other sites are the same drivers/versions as this one. While this hardware was on our bench being setup we didn't get these messages. Just seeing if the community had any input on the issue. My gut is telling me some type of routing issue in the network, a faulty switch, or maybe bad switch firmware. I don't think it is the bnx2x driver but this one is tough to tell. Appreciate any input!
↧