Hi Everybody!
I have searched through the forums and haven't found any question answering this. I have Proxmox 3.2 installed on a hard disk and in the system I have 2 other hard disks that are exactly the same. What I want to do is take those two hard disks in a single volume group and then on an identical node with the same setup and volume group set up DRBD. Essentially instead of a DRBD volume with 80gb I would have one with 160gb. I was just wondering if this is possible and if so how could I go about doing it?
Thanks,
Nick
I have searched through the forums and haven't found any question answering this. I have Proxmox 3.2 installed on a hard disk and in the system I have 2 other hard disks that are exactly the same. What I want to do is take those two hard disks in a single volume group and then on an identical node with the same setup and volume group set up DRBD. Essentially instead of a DRBD volume with 80gb I would have one with 160gb. I was just wondering if this is possible and if so how could I go about doing it?
Thanks,
Nick