Open vSwitch configuration in 3.2

Hi guys, Im new here but have been testing Proxmox as a potential replacement for a large VMWare ESXi environment and so far I think it is excellent!

I have just installed 3.2 on a test box and installed the openvswitch package. I am looking for some guidance on how to configure it in Proxmox VE 3.2.

My host has 2 NIC's, eth0 and eth1. I want to bond them in an active-backup configuration. There are 3 VLAN's trunked to the host. 10, 20 and 50.

How would I go about setting this up using OVS? With standard linux bridging & bonds I would create a bond for every VLAN such as bond0.50, bond0.10 etc.... Then create a bridge to each of those bonds.

I don't quite understand how to do the same with OVS and take advantage of its features.

Thanks
Tom