I had a scary this morning stating that the automated backup I run on one of my Proxmox hosts had failed.
It turns out it failed on the following -
VM105 actually has a single disk that is set to "No Backup" so the reason it failed is because it simply did not have any devices to backup, but I'd rather not take the backup settings off "All" in the Datacenter tab as otherwise I could end up missing any new VM's are provisioned.
Is it possible to make the status checking a bit smarter e.g this should really be Skipped instead of Failed?
It turns out it failed on the following -
| 105 | Ubuntu-storage | FAILED | 00:00:01 | empty device list | |
VM105 actually has a single disk that is set to "No Backup" so the reason it failed is because it simply did not have any devices to backup, but I'd rather not take the backup settings off "All" in the Datacenter tab as otherwise I could end up missing any new VM's are provisioned.
Is it possible to make the status checking a bit smarter e.g this should really be Skipped instead of Failed?