I'm doing some test with 2 virtual installation of proxmox 3.0 configured as cluster.
In the wiki: http://pve.proxmox.com/wiki/Proxmox_VE_2.0_Cluster
I see that the 'pvecm status' diplays a very nice table with nodes active, uptime, load etc.
If I run the same command on one node of 3.0 version I get something different, like:
is there a new command that gives me the same output as in the wiki, or some additional parameters?
Thanks in advance
In the wiki: http://pve.proxmox.com/wiki/Proxmox_VE_2.0_Cluster
I see that the 'pvecm status' diplays a very nice table with nodes active, uptime, load etc.
If I run the same command on one node of 3.0 version I get something different, like:
Code:
Version: 6.2.0
Config Version: 2
Cluster Name: mytestcluster
Cluster Id: 4916
Cluster Member: Yes
Cluster Generation: 80
Membership state: Cluster-Member
Nodes: 2
Expected votes: 2
Total votes: 2
Node votes: 1
Quorum: 2
Active subsystems: 5
Flags:
Ports Bound: 0
Node name: prox01
Node ID: 1
Multicast addresses: 239.192.19.71
Node addresses: 192.168.99.100Thanks in advance
