Subject should be SSD + RAID
I have a new to me IBM x3455 box with 20gb ram. I plopped a 128gb SSD as SATA 0, there was an 80 gb on SATA1 and I've installed 150gb hardware RAID on PCI bus. WHen I go through the install I get it installed on the SSB and I can boot to it.
IF I try to shutdown the system it croaks and fails and when I attempt a reboot it can not boot since it can't find the image it seems. I does boot the proxmox boot manager and then will fail.
This is with v3.0 and I believe 2.3 when I tried it did similar.
Any ideas? ALso, when looking at the drives with the DFSee utility it seems only a portion of the SSD was installed and the other drives were not used.
Thanks leon
I have a new to me IBM x3455 box with 20gb ram. I plopped a 128gb SSD as SATA 0, there was an 80 gb on SATA1 and I've installed 150gb hardware RAID on PCI bus. WHen I go through the install I get it installed on the SSB and I can boot to it.
IF I try to shutdown the system it croaks and fails and when I attempt a reboot it can not boot since it can't find the image it seems. I does boot the proxmox boot manager and then will fail.
This is with v3.0 and I believe 2.3 when I tried it did similar.
Any ideas? ALso, when looking at the drives with the DFSee utility it seems only a portion of the SSD was installed and the other drives were not used.
Thanks leon